Width:      32", 63", 94", or 120" (813 mm, 1600 mm, 2388 mm, or 3048 mm)

Depth:      26” (standard), 27 ¼” (660 mm, 692 mm)

Height:     38” (standard), 38 ¾“ (965 mm, 984 mm)

Construction

CMP Surgical Scrub Sinks are constructed of type 304 stainless steel with No. 4 finish.  All corners are welded, and all welds are ground and polished to match No. 4 finish. Hands free water control is accomplished either by pressing a front panel with the knee or by an electronic infrared sensor (see various models & options).

The sink is constructed of No. 16 gauge stainless steel with horizontal and vertical corners coved to 1/4" radius. The underside of the sink is coated with sound deadening material. The sink is designed to eliminate backsplash.  Each station is equipped with a 2" I.P.S. stainless steel drain, an anti-splash spray arm, and a removable Plexiglas partition to isolate each bay.

The outer sink enclosure is made of No. 18 gauge stainless steel and has easy to remove hinged stainless steel panels on the front for access to plumbing and controls.

Controls

CMP scrub sinks all have a thermal, non-electric (no shock) adjustable hot and cold water mixing valve with pressure balancing control for maintaining constant water temperature. The mixing valve is adjustable by the user via a hand control, which is on the top of the sink on all models other than the standard model. Preset high limit stops in the valve prevent water flow in excess of 115 deg. F.

Each bay has its own water-flow control. On the Standard and AS ("Manual") models, the water is turned on and off using the knee-control panel. On the Automatic model the water is turned on for a set time by pressing an electronic touch pad at the top of the sink. The electronic control model activates the water flow automatically when the user's hands are placed under the spout.

Installation

Sinks are supported by two or more chair carriers, supplied by others (optionally available from CMP). Alternatively, a stainless steel pedestal base may be ordered for supporting the sink from the floor.

Service connections required are a 3/4" I.P.S. hot water and a 3/4" I.P.S. cold water feed and 2" I.P.S. waste for each bay.

Available Models

Available Options

Stainless Steel Pedestal Base for Floor Mounting                                                

In-Wall Chair Carrier System for Wall Mounting

Adjustable Manual Timers

Digital Display Timers, with Pre-Set l, 3, 5 or 10 minute cycles (I20 VAC service required)

Knee-Operated Soap Dispenser Pump

20-Watt Light (120 VAC service required) for Illuminating Each Bay

Stainless Steel Wall Shelf for Mounting Above Sink

Emergency Manually Activated Water Flow for Electronic Sinks